GP2D010A120B

Introduction

The GP2D010A120B is a sensor designed for proximity detection and distance measurement. This entry provides an overview of the product, including its category, use, characteristics, package, essence, packaging/quantity, specifications, detailed pin configuration, functional features, advantages and disadvantages, working principles, detailed application field plans, and alternative models.

Product Overview

Category: Sensor
Use: Proximity detection and distance measurement
Characteristics: Compact, accurate, reliable
Package: Integrated circuit
Essence: Utilizes infrared light to measure distance
Packaging/Quantity: Varies by supplier

Specifications

Operating Voltage: 4.5V to 5.5V
Detection Range: 10cm to 80cm
Output Type: Analog voltage
Power Consumption: 33mA (typical)

Detailed Pin Configuration

VCC - Power supply input
GND - Ground
Vo - Analog output

Functional Features

Accurate distance measurement
Compact size for easy integration
Low power consumption
Reliable performance in various lighting conditions

Advantages

Wide detection range
Simple interface for integration
Consistent and reliable measurements

Disadvantages

Limited accuracy at very close distances
Susceptible to interference from ambient infrared sources

Working Principles

The GP2D010A120B operates on the principle of triangulation using infrared light. It emits a modulated infrared beam and measures the time it takes for the beam to be reflected back to the sensor. By analyzing the reflected signal, the sensor calculates the distance to the target object.

Detailed Application Field Plans

Robotics: Used for obstacle detection and avoidance
Industrial automation: Distance measurement for positioning and control systems
Consumer electronics: Proximity sensing for touchless interfaces

Detailed and Complete Alternative Models

Sharp GP2Y0A21YK0F: Longer detection range
Pololu Carrier with Sharp GP2Y0A60SZLF: Higher resolution and longer range

In conclusion, the GP2D010A120B sensor offers a compact and reliable solution for proximity detection and distance measurement. Its wide range of applications and straightforward integration make it a versatile choice for various projects.

[Word count: 346]

Sebutkan 10 pertanyaan dan jawaban umum terkait penerapan GP2D010A120B dalam solusi teknis

What is the GP2D010A120B sensor used for?
- The GP2D010A120B sensor is commonly used for distance measurement in technical solutions.
What is the operating voltage of the GP2D010A120B sensor?
- The operating voltage of the GP2D010A120B sensor is typically around 5V.
How does the GP2D010A120B sensor measure distance?
- The GP2D010A120B sensor measures distance using infrared light and triangulation principles.
What is the range of the GP2D010A120B sensor?
- The GP2D010A120B sensor has a typical range of 10cm to 80cm.
Can the GP2D010A120B sensor be used outdoors?
- The GP2D010A120B sensor is primarily designed for indoor use and may not perform reliably outdoors due to ambient light interference.
What are the output characteristics of the GP2D010A120B sensor?
- The GP2D010A120B sensor typically provides an analog output voltage proportional to the measured distance.
Is the GP2D010A120B sensor affected by ambient light?
- Yes, the GP2D010A120B sensor's performance can be affected by ambient light, so it's important to consider lighting conditions in the application.
Can the GP2D010A120B sensor be used in robotics applications?
- Yes, the GP2D010A120B sensor is commonly used in robotics for obstacle detection and avoidance.
What are the typical applications of the GP2D010A120B sensor?
- Typical applications of the GP2D010A120B sensor include robotics, automation, and proximity sensing in various technical solutions.
Are there any calibration requirements for the GP2D010A120B sensor?
- Calibration may be necessary to ensure accurate distance measurements, especially if environmental conditions change significantly.