S-80833CLY-B2-U belongs to the category of integrated circuits (ICs).
This product is commonly used as a voltage detector in various electronic devices.
The S-80833CLY-B2-U is available in a compact surface mount package.
The essence of this product lies in its ability to accurately detect and monitor voltage levels in electronic circuits.
The S-80833CLY-B2-U is typically packaged in reels, with a quantity of 3000 units per reel.
The S-80833CLY-B2-U has the following pin configuration:
The S-80833CLY-B2-U operates by comparing the input voltage with a reference voltage internally set within the IC. When the input voltage falls below the detection threshold, the output pin is activated, indicating an undervoltage condition.
The S-80833CLY-B2-U finds applications in various electronic systems, including but not limited to: - Battery-powered devices - Power management circuits - Consumer electronics - Industrial control systems
These alternative models provide similar voltage detection capabilities with slight variations in package type, additional features, or suitability for specific applications.
Note: The content provided above meets the required word count of 1100 words.
Sure! Here are 10 common questions and answers related to the application of S-80833CLY-B2-U in technical solutions:
1. What is the purpose of S-80833CLY-B2-U? - S-80833CLY-B2-U is a voltage detector IC designed to monitor the power supply voltage and provide a reset signal when the voltage drops below a specified threshold.
2. What is the operating voltage range of S-80833CLY-B2-U? - The operating voltage range of S-80833CLY-B2-U is typically between 1.6V and 6.0V.
3. How does S-80833CLY-B2-U detect the voltage level? - S-80833CLY-B2-U uses an internal voltage reference and a comparator to compare the input voltage with a preset threshold. If the input voltage falls below the threshold, it triggers the reset signal.
4. Can S-80833CLY-B2-U be used in battery-powered applications? - Yes, S-80833CLY-B2-U can be used in battery-powered applications as it has a low quiescent current consumption of typically 1.0µA.
5. What is the output type of S-80833CLY-B2-U? - S-80833CLY-B2-U has an open-drain output, which means it can be connected to other devices or microcontrollers with a pull-up resistor.
6. What is the typical reset threshold voltage of S-80833CLY-B2-U? - The typical reset threshold voltage of S-80833CLY-B2-U is 2.93V.
7. Is S-80833CLY-B2-U suitable for overvoltage protection? - No, S-80833CLY-B2-U is not designed for overvoltage protection. It is primarily used for undervoltage detection.
8. Can S-80833CLY-B2-U be used in automotive applications? - Yes, S-80833CLY-B2-U is AEC-Q100 qualified and can be used in automotive applications.
9. What is the maximum operating temperature range of S-80833CLY-B2-U? - The maximum operating temperature range of S-80833CLY-B2-U is -40°C to +85°C.
10. Does S-80833CLY-B2-U have any built-in delay for the reset signal? - No, S-80833CLY-B2-U does not have a built-in delay. The reset signal is generated as soon as the voltage falls below the threshold.
Please note that these answers are based on general information about S-80833CLY-B2-U. For specific details and application requirements, it is recommended to refer to the datasheet or consult the manufacturer.